Vertex Gel 6010 Epoxy Adhesive

How-To Guide for Using Vertex Gel 6010 Epoxy Adhesive:

Step 1: Surface Preparation:

1. Clean the Surfaces: Ensure both surfaces to be bonded are clean, dry, and free of dust, grease, oil, and other contaminants. Use a suitable cleaner and allow them to dry completely.
2. Roughen the Surfaces: For optimal adhesion, lightly sand or roughen the surfaces to create a mechanical bond for the epoxy.

Step 2: Mixing:

1. Measure Components: Accurately measure the required amounts of Component A (resin) and Component B (hardener) using the provided measuring cups or scales. The exact mixing ratio is typically 4:1 (Component A to Component B), but always refer to the product label for the specific ratio.
2. Mix Thoroughly: Combine the measured amounts of Component A and Component B in a clean, dry container. Mix thoroughly using a spatula or mixing stick until a uniform, bubble-free mixture is achieved. Avoid incorporating air bubbles during mixing.

Step 3: Application:

1. Apply the Epoxy: Apply the mixed epoxy to one of the surfaces to be bonded using a spatula, brush, or other suitable application tool.
2. Join the Surfaces: Immediately join the two surfaces together, ensuring proper alignment.
3. Apply Pressure: Apply firm, even pressure to the bonded surfaces to ensure a strong bond.
4. Remove Excess: Remove any excess epoxy with a spatula or scraper before it hardens.
5. Allow to Cure: Allow the epoxy to cure completely according to the specified curing time on the product label. Curing times can vary depending on temperature and humidity.

Safety Precautions:

• Wear appropriate protective gear, such as gloves, safety glasses, and respiratory protection, when handling epoxy resin.
• Ensure adequate ventilation during mixing and application.
• Keep the product away from heat and open flames.
• Keep out of reach of children.
• In case of contact with skin, wash thoroughly with soap and water.
• In case of contact with eyes, rinse¹ immediately with plenty of water and seek medical attention.
• If ingested, seek medical attention immediately.

Tips:

• Test the epoxy on an inconspicuous area first to ensure you achieve the desired results.
• For best results, apply the epoxy in a well-ventilated area on a warm, dry day.
• If you experience any difficulty with application or achieve uneven results, consult with a professional for assistance.

Remember: This guide provides general instructions. Always refer to the product label for specific instructions, safety information, and technical data sheet for complete details.

Disclaimer: This information is provided for general guidance only and should not be considered professional advice. The user assumes all risks and liabilities associated with the use of this product.